Vacuum pump units in oil processing operations _

vacuum pump unit or any other mechanical equipment, it is inseparable from the lubricating oil, because oil can effectively help equipment work better. But, this kind of lubricant can not maintain its function for a long time. It need according to the device used to change the oil. Because of long time work, set the pollution of oil quality will be affected by a variety of external factors, otherwise if replace lubricating oil in time, can cause damage to the unit. Therefore, here small make up about some processes, oil change unit for operation, to help you work more smoothly.

1。 When the vacuum pump oil change device, the water pump should be removed from the vacuum system should be paid attention to in the first place.

2。 Later, the chassis of the motor end should be increased. Open the fuel drain plug to discharge of oil, rotating device, keep the vent, let all the dirty oil from exhausted from port of discharge in the chamber, and adding new oil from the air inlet. Oil 100 - Ml continuous rotation 5-500 10 or more RPM for internal cleaning, this 3 - operation 5 times.

3。 Remove oil, grease, will pump flat, respectively from the air inlet and the oil hole to join the new oil, oil change.

4。 When the vacuum pump oil change device, start the motor for a long time is not recommended. At this point, the exhaust valve would be too severe and fatigue.

5。 Vacuum water pump units in oil, still should ban the use of kerosene, gasoline, alcohol, etc to clean the disassembly of the water pump.

6。 If the pump to stop for a long time, the attention should be paid to remove the exhaust hood, and closing the air intake and drainage vent plug.

everyone need to know the lubricating oil to the influence of the vacuum pump unit is very good, not only can reduce the unit internal parts wear, also can make the parts run smooth and flexible, but if the lubricating oil contamination and full of impurities, so these good effect will be getting worse, increase the wear parts, making them unable to work normally, and so on. Therefore, when change the operating equipment, everyone must be correct and careful.