To pay attention to when feeding pump of pressure filter into the device

when feeding pump of pressure filter into the device should pay attention to matters of

feeding pump of pressure filter in using professional determine its needs regular check and clean. Regular cleaning filter cloth, daily cleaning. Look into daily operation using the equipment, operation state is outstanding, to replace damaged parts. About car bearing, piston rod, pull board, sprocket chain and other parts should time lubricity, sticking to its flexible operation. The protection of hydraulic system, main is to look at the hydraulic components and the maintenance of each interface sealing, to stick to its normal operation. Feeding pump of pressure filter into the new work a week for the first time to replace a hydraulic oil, oil change to make fuel tank and oil used in cylinder of the hydraulic oil clean and wipe the tank. The best six months in a oil, keep the outstanding operation state, extend using life.

feeding pump of pressure filter into the pump head part of the assembled

1, the first on the feeding pump of pressure filter into the pump shaft device o-rings, remove the ring, shaft sleeve, and then lifting water pump body, pump body with bolts on the bracket;

2, the pump cover part of the mount gasket, guard board, before finally mounted pump body, pump cover;

3, decompression device cover, sealing pads, lifting plate, after using bolts on the pump body, impeller o-rings, hoisting impeller, sheath, the sheath with bolt and fixed clamp pressure on the pump body;

4, when the device must pay attention to the gasket must be put in correct position and pressure;

5, then tighten bolts pump cover, pay attention to the direction of the water pump cover bolts, symmetric device.

feeding pump of pressure filter into the bearing component installation:

1, installation to preheat the bearing, oil temperature should not exceed 120 ° commonly;

2, about the bearing gap, products is ready to adjust before they go out, usually at 0. 2 - 0. About 5 mm, but the user when disassembling repair or replace new bearing should pay attention to is: in order to ensure the bearing gap, should be in between bearing gland and the bracket body moulding paper pad of feeding pump of pressure filter into the bearing components gap adjustment, to ensure that the bearing assembly gap in 0. 2 - 0. 5.

feeding pump of pressure filter into the installation part is mainly composed of the above two parts, each part of the installation should be strict when assembled in accordance with the requirements, any unreasonable installation may cause big problems, strict quality control standards, making the quality of feeding pump of pressure filter into the product.

are an important part of the society and they come in handy in any place where there are pool cover drain pump in need of winter cover pump.
To learn more about submersible pump， give us a call at J&T INDUSTRY CO.,LTD. or visit us online by going to J&T INDUSTRY.
This is crucial when you need to maintain innovative information in submersible pump.
Basically, you cannot have a pool cover drain pump without having the right submersible pump. Since you are going to use it regularly, be sure to invest in one that has a high quality.
People tend to want what they perceive they cannot have. Making JT seems exclusive or as if it will go out of stock if they don't act quickly often makes it more enticing to the consumer and increases the likelihood that they will buy in.