Titanium axial-flow pump appearance should be how to cleaning

how to clean the titanium axial-flow pump appearance

titanium axial flow pump, safe and reliable use convenient shorthand, no special requirements, the well tube, Yang pipe compared to common titanium axial flow water pump has longer using life. Today small make up a brief introduction of how to clean the appearance of titanium axial-flow pump:

1, the trademark of the stainless steel appearance, sticker when warm water may be weak washing agent to clean, binder composition should use alcohol or organic solvent washing.

2, titanium axial-flow pump appearance may easily out of dirt, dust weak sex can use soap washing agent may said flushing.

3, when the stainless steel is the rainbow lines, the main reason is because of too much washing agent may be oil, rinse with warm water when neutral cleaning agent can be washed clean.

this is some proposition about pump in vitro table clean. Titanium axial-flow pump corrosion resistance is stronger, running low noise, high efficiency, stable performance, can meet the requirements of deep water and drinking water supplies and all kinds of the use of irrigation works

titanium axial-flow water pump safety

titanium axial flow pump is used in underwater equipment, and in order to in electricity use of cent can be safer, we in the use of security measures must be in place, in nowadays equipment caused by danger, in order to prevent this phenomenon, we can only start from the little things bit by bit, only better grasp its protective measures, talents to further protect the quality of the products, such as the following these is must be guaranteed.

1, leakage protector, titanium axial flow pump in underwater operation, if the present leakage will form the loss and even cause accident getting an electric shock. Titanium if equipped with leakage protector, as long as the axial flow pump leakage power beyond must value, and the power of the leakage protector will block the titanium axial flow water pump, prevent waste electricity leakage, ensure safety.

2, moved to and nameplate of the motor steering, prevent burning. To dangling device, cable, power cord can't be too long.

3, do not frequently launch a titanium axial flow pump, this is because the electric pump stalling reflux happens, if the boot immediately, can make the motor load, leading to a burn winding current is too large.

there is in the use of titanium axial flow pump, we always check the motor, such as found by the crack, damage to the rubber sealing ring, or failure to immediately replace or correction, prevent leakage accident, do a good job in security work. Not just in the process of the device, also demand especially pay attention to in use, if once found that titanium axial flow pump is abnormal, immediately stop for maintenance, in order to prevent the failure.