Three horizontal centrifugal pump installation method: center line of alignment, horizontal alignment, vertical alignment

Whatever horizontal centrifugal pump before use it to the correct installation, if installed incorrectly can cause a centrifugal pump can't use even will result in a centrifugal pump damage etc. Phenomenon, should review the basic level and elevation before the pump in place. The centerline of the pump to align, horizontal alignment, vertical find it is the key in the process of installation.

1, the center line of the horizontal centrifugal pump and searching to find is the center line of the

longitudinal and lateral centerlines are is to look for is the water pump. First a good basis for longitudinal and lateral centerlines of the top surface, and then in the pump inlet and outlet flange surface ( Double suction centrifugal pump) And the center of the shaft hanging vertical, respectively. Based on position adjusting pump, vertical and longitudinal and lateral centerlines of the match.

2, level of horizontal centrifugal water pump is looking for is

level is to look for is the pump longitudinal and transverse level. Generally, using the method of level or hanging vertical single-stage centrifugal pump measured on the pump shaft and outlet flange.

double suction centrifugal pump in the water pump inlet and outlet flange surface measurement, use the method of adjusting shim, the level of bubble in the middle, or make the flange surface to the distance apart is exactly equal to the length of vertical or with vertical overlap. Horizontal double-suction centrifugal pump can also be opened in the level of the pump shell, the choice can be associated with cross-shaped four points on the grade rod set on the four points, use level reading reading of each level ruler if the reading is equal, the water pump of the longitudinal and transverse horizontal alignment at the same time.

3, horizontal centrifugal pump elevation is

find pump elevation refers to the height of pump shaft axis. Elevation is the purpose of the alignment check and design elevation height of pump is installed, use level and the level ruler to measure. When measuring a point elevation Hs level ruler in known level, will be another level ruler on the pump shaft.

J&T INDUSTRY CO.,LTD. have now decided to extend our company in other countries.
J&T INDUSTRY CO.,LTD. also values the time, skills, and expert opinions of our staff. We are committed to providing fair and living wages, reasonable, structured work schedules, and clear duties and spheres of rights and responsibilities for each team member.
J&T INDUSTRY CO.,LTD. believes that the average profitability will be sufficient.
There is growing awareness about the health benefits of among the consumers resulting in its increasing popularity.