The use of chemical axial flow pump

the use of chemical axial-flow pump note

in nowadays chemical axial flow pump is used very widely in agriculture, it can not only advance the efficiency of agriculture, but also reduce the human cost, on many large agricultural products is a very economical. But broad farmers of axial flow pump don't really know, doesn't maintain its application methods are problematic, even it will drop pump using the stature and working efficiency greatly. Below my face about several matters needing attention of chemical application of axial flow pump.

1, punctual to boot

in the pump don't have time for a long time we should also be punctual to boot to prevent rust, general open once a week.

2, voltage disturbance is unfavorable boot

in the high voltage is too low will pump overheating, then shorten their life spans and even burn it.

3, should not be frequently initiated

chemical axial-flow pump things should not be launched again and again, because in the water pump is there will be a return, immediately launched a can make the motor load.

chemical problems in operation of axial-flow pump, because the chemical elements of axial flow pump work environment and time, inevitably some problems, in order to advance the work efficiency, we must find out the reason and timely cleaning chemical problem of axial flow pump.

1, chemical axial-flow pump operation have abnormal vibration, unstable: chemical axial-flow pump operation have abnormal vibration, the main cause of instability and cleaning methods:

( 1) Water pump base anchor bolt is not tight or loose.

( 2) Water pipeline without independent support, pipeline vibration influence on the pump.

( 3) Impeller unbalanced quality and even damage or loose equipment.

( 4) up and down bearing damage.

2, lack of chemical axial-flow water pump or water flow, chemical often appear in operation process axial-flow water pump and a lack of or is not the main cause of water and cleaning methods:

( 1) equipment height is too high, making the impeller submersion depth, led to the decrease of the water pump water yield.

( 2) The pump to the opposite.

( 3) Water valve cannot open.

( 4) Water line is not clear or impeller stuck.

( 5) The lower pump abrasion and circle or severe blocked by debris.

( 6) Excessive pumping liquid density or viscosity is too high.

3, chemical not turn when the axial flow pump: chemical industry of the main causes of axial flow pump can't launch and cleaning methods:

( 1) The power switch and plug contact is bad.

( 2) Control circuit insurance burned down.

( 3) Insurance of primary loop.

( 4) Three-phase chemical axial flow phase.

If you have a winter cover pump business, be sure to choose a from J&T INDUSTRY CO.,LTD.. After all, you need quality equipment in order to provide your customers with quality service.
J&T INDUSTRY CO.,LTD. attaches great importance to customers and assists them in achieving their demands.
The proprietor has many years experience in providing promotion services and is a sought after expert in submersible pump.
A technology team created for insuring that submersible pump is produced with the finest materials and technologies.
Our company is professional in manufacturing submersible pump especially pool cover drain pump.