The base of the self-priming pump installation instructions

the installation of self-priming pump, self-priming pump installation instructions

self-priming pump installed correctly and solid foundation is an important factor of self-priming pump and low noise. In order to make the self-priming pump operation, at the best condition of self-priming pump installation instructions as follows:

1, self-priming pump base, and between the concrete base with the method of direct fastening, can eliminate the unbalanced tolerance.

2, between concrete foundation and building structure with elastic isolation, can prevent the self-priming water pump vibration is passed to the building structure.

3, the width of concrete base size, should be more than the self-priming pump base width is 15 ~ 20 cm.

4, installing a self-priming pump pipe road, to avoid the pump under other external forces: near the water pump inlet and outlet pipe, to install fixtures, avoid management for water pump power.

5, self-priming pump after the installation is complete, must carry on the pump to adjust, because the water pump in the transportation and installation process will be dislocation; To the accuracy requirement: coupling between 4 - shall be maintained 6 mm clearance, end face standard deviation is 0. Less than 2 mm; The pump and motor shaft centerline to maintain consistent, radial runout shall not exceed 0. 2mm。

u special remind: in order to ensure the pump reasonable damping, sound insulation, noise reduction, please consult relevant professionals based design. Small self-priming pump doesn't need so complicated, such as small self-priming pump products or corrosion resistant stainless steel self-priming pump don't have this installed.

self-priming pump base installation diagram below

related articles: self-priming pump installation note

need to know information about self-priming water pump products can view selection of self-priming pump series.