Rotary-vane vacuum pump are clean and assembly - need to pay attention to

rotary vane vacuum pump is a new type of equipment. When we arrived at the time, the dust will cover it in the air. At this point, it is necessary to remove and clean inside and outside. The following are some points of cleaning and assembly equipment:

1. Assembly before the

( 1) First type high vacuum cleaning and drying, so that the assembly. Mention spring rotor, and install it into the high rotor. And then in the high vacuum indoor, installing the front plate, installation positioning pin, evenly tighten the screw.

( 2) After assembly, rotation should be flexible. Easy. Evenly. Then after installing low vacuum rotor and end cover. Low rotor slot should be toward the back end plate. When installing exhaust valve, exhaust valve should be close to the valve plate and other parts.

2。 The assembly should be paid attention to: all rotating parts should be coated with vacuum oil. It is forbidden to iron. The mud. Sand and dust into the water pump. Locating pin should be well connected. Installation of the pump should be able to easily rotate and uneven rotating weight, not blocking phenomenon.

3。 Remove the location of the parts should be paid attention to. The direction and combination tightness. Removed parts should be placed separately, should not be mixed together to wear.

4。 Check rotary-vane vacuum pump are all parts and see if they wear. Rough or damaged. According to the situation to repair or replace them.

5。 Please note that, if found in the front plate and the back-end degree big scratches, this means that the rotor is not perpendicular to the middle baffle plate in the assembly process, and locating pin should be adjusted. If it is too serious, should repair or replacement.

6。 Remove the pump from the vacuum system. After first dismantle and low vacuum side, remove the end plate, and then dismantle and low vacuum rotor and keys, and then remove the front panel, remove the vacuum pump rotor and rotor. Spring, etc. Remove the observation window. The exhaust valve and exhaust cover, thoroughly clean all parts with gasoline or alcohol.

7。 After assembly, separately from the air inlet and lubrication oil, the oil into endoscopic horizontal line, and then test.

rotary vane vacuum water pump for the machine to remove when cleaning. When we finish cleaning and drying, need according to the procedures for assembly, so can greatly save time, can also extend the service life of equipment, improve the work efficiency.

J&T INDUSTRY CO.,LTD. has various branches in local businesses, servicing customers and helping to pull in traffic to those businesses.
Check out J&T INDUSTRY for optimal quality products, and get your water pump problem fixed. Send us an enquiry or make a call if you are interested.
Lucky to know that you are not alone in the face of winter cover pump issue. Let J&T INDUSTRY CO.,LTD. be your selected water pump expert in providing first class to help you out.
water pump are less complex compared with pool cover drain pump.
We should take a step back to review how JT approach tracking, implementing, and communicating compliance-related changes and attempt to identify areas of improvement in their processes.