Pump industry suppliers - Titanium and application characteristics of axial flow pump

Titanium characteristics of axial flow pump and using the

1, the application and the management method of titanium axial-flow pump is a kind of high speed pump, general specific speed than in the middle of the 500 ~ 1000. Because the more the greater the speed, the lower the water pump head, the greater the total flow, when it starts not to row out of the line gate turn off, or start the output power is too large, will cause the motor load and destruction. Titanium choose adjustable axial-flow pump type axial plunger pump to adjust traffic.

2, characteristics and use of titanium axial flow pump has the advantage of large total flow, simple structure, lighter weight, small size, small space. Raises the integral expression of titanium axial flow pump, when work standards change, if change the leaf Angle, still can maintain in relatively high efficiency in work, but because of the low hm restricted its use category. In order to promote hm, titanium axial-flow pump can also be made into multistage else. Titanium titanium axial-flow pump cavitation characteristic is weak, because the axial flow pump has the characteristics of itself, thus big traffic is one of the development prospect of the titanium axial flow pump.

titanium axial-flow pump equipment start-up and shutdown take steps:

1, the gasoline pump, wary of the pump shaft is appropriate. Titanium axial flow pump are produced in the whole work process such as vibration and sound 矂 obviously, there are will be a pump cavitation cause.

2, pay attention to negative pressure gauge and read value table. Starts when the barometer and negative pressure table read value after a period of 'between the ups and downs and smooth after. That already on liquid water pump, gasoline pump blend into the normal oil pipe work.

3, pump in the whole work process due to stop the pump. Need to restart, inward and outward pressure regulating valve should be slightly open, as both are beneficial to the whole process naturally aspirated RGL body from spit out entrance discharged. And to ensure the pump under light load starting.

4, before the pump into the normal oil pipe work is naturally aspirated, during the whole process should pay attention to the pump high oil temperature in idle condition, if the process is too long, pump in the oil temperature is too high, stop the pump to check its account.

5, if the temperature is too high and cause naturally aspirated liquid in the pump, so to temporarily shut down, using the spit out of the pipeline inside the liquid flow back to pump or to add reservoir on the pump casing mouth immediately to fill liquid pump, titanium cooling liquid in the axial flow pump. Then start the can.

submersible pump pool cover drain pump has gained a lot of popularity over the recent past.
J&T INDUSTRY CO.,LTD. is one of leading winter cover pump submersible pump distributors. You can order , and accessories for your need. Meeting your business need is always our top priority. Any of your enquiry is warmly welcomed.
J&T INDUSTRY CO.,LTD. is a new company that provides expertise in search marketing solutions for business on a worldwide basis.