Pump industry suppliers - The processing of titanium alloy pump leakage

pump structure is mainly composed of titanium alloy, bushings, stuffing box, packing, water seal, etc.

1, shaft sleeve, is used to protect the shaft, to prevent liquid corrosion of shaft and the shaft is not directly with packing friction.

2, water seal: is the water seal ring ( Beginning on page 191) Add in seasoning culvert, and the external water pipe, water seal ring at the work of the holes and grooves to form water around the ring, so as to prevent air leakage into the pump. Can also play the role of lubrication and cooling packing and shaft sleeve, to prevent packing and shaft sleeve of a lot of wear and tear.

3, stuffing box and packing: ( Packing box and packing) Play to the role of external and internal partition pump housing, in order to reduce leakage.

the processing of titanium alloy water pump leak:

1, the working process, to reduce the leakage should be first to packing is installed in the correct manner.

1) Should first will be thoroughly cleaned up stuffing box, and check whether the shaft sleeve and the outer surface of the stuffing box is in good condition, with or without obvious wear and tear.

2) Packing specification should be chosen according to the rules, performance should be adapted to lose by liquid, size should comply with the requirements. Carefully will leak.

3) Cutting edge sharp, when packing interface to 30 o ~ 45 o Angle, cut into section should level off. Cut after packing is installed within the stuffing box must be a whole round, not shortage, not very long.

4) After tightly on the packing, should check the packing gland and the clearance between shaft, the clearance should be around the same; Check the gland around the amount of pressure is the same. Prevent the gland and the shaft friction.

5) Mount a circle after packing, tighten gland packed and uniform, until confirmed packing already in place. In loose packing gland, tighten the new to appropriate tension force. （ After general loading packing first not tight or a little bit tight force, after water injection pump in the tight packing, but let the packing have traces of leakage. starts, according to the packing in leakage and temperature tight packing. ）

check after the titanium alloy water pump filling packing:

check tighten packing gland nut and tighten the suitability, tension is too large, while reducing leakage, but will cause friction between packing and shaft sleeve surface increases, serious when can fever, smoke, until the packing and sleeve burned; Tension is too small, big leakage. Power must be appropriate, therefore, should be to gradually reduce the liquid through the clearance between the shaft sleeve and packing pressure and form a layer of water film, which increase lubrication, reduce friction and shaft sleeve for cooling. Titanium alloy pump after the start, should maintain a small amount of liquid from escaping from the stuffing box is preferred. Can be adjusted after the pump start-up gland force.

J&T INDUSTRY CO.,LTD. is different from other companies as we provide timely and unique services to our respected clients.
What are you waiting for? Get out there and buy some of the most effective at J&T INDUSTRY.
J&T INDUSTRY CO.,LTD. knew if this worked for us, it would work for others, so we took the exclusive product and program and re-developed it to be more accessible to customers.
Many business owners and professionals use services like J&T INDUSTRY CO.,LTD. to stay on top of manufacturing industry, monitor products’ quality and keep an eye on competitors.
The lower cost of submersible pump, compared to other product, and J&T INDUSTRY CO.,LTD.’s services provide may well suit the needs for customers.