Pump industry suppliers - How to install the gypsum slurry pump public base

public base and how to install the gypsum slurry pump in the alignment process supervision and inspection of the following:

1) For the pump installation to produce flat washer and inclined block group.

2) Along the anchor bolt, after basic concrete condensation pump, electric motor protection, clear the part of the block, to make the base of the in-situ stress to a minimum. Each piece of flat block wall should choose level ground leveling. Flat block ratio without a unified ground leveling, because when the base flat pad after installation height to width ratio is changed from inclined block.

3) When bonding pad of concrete after condensation, the base ( Installed and motor) Placed on the inclined block. Check height to width ratio of the pump shaft, put a level in the drain flange surface, with oblique pad to adjust pump radial and lateral smoothness.

4) After the pump parts and clear sea level, the use of special tools temporary of the pump and motor. Please record temporary value, in the coaxial degree after inspection will be effective.

5) After temporary for the anchor bolt hole pouring concrete.

6) When gypsum slurry water pump concrete pouring to the anchor bolt hole after condensation, please twist firmly anchor bolt nut.

7) For even the shaft coupling after inspection, please send cement mortar pouring on earth every corner of the, don't leave all the gaps.

8) Are described in the process, installation into the pipe and the outlet. Gypsum slurry pump and ductility column pin coupling coupling shaft device coupled to gypsum slurry pump standard types, according to the following process of the pump and motor.

9) Used for circulating water cooling, sealing and cooling water circulating water auxiliary piping and competent, appropriate to install them, it is not easy to make it their release on the pump is not looking forward to the mutual acting force. Before installation, make sure not leave residue in the tube. If so, please eliminate residue in the pipeline before installation.

10) After wearing pipe, please check again on the pump and motor, in order to make sure with mild-to-moderate did not suffer wear tube the influence of the additional external force during the whole process.

pump industry suppliers is the collection scientific research, design, production, management, services for the integration of production enterprises, the company has a modern self-priming pump performance testing methods, equipments. Main production ZA, ZAO, gypsum slurry pump, CZ chemical process pump, IH chemical pump, forced circulation pump, SPP chemical mixed-flow pump 28 species such as qualitative, 30 series more than 1000 specifications special alloy chemical pumps, valves, stainless steel pipe, fluorine pipe parts. 。