Pump industry suppliers - Chemical axial-flow pump repair and maintenance

chemical features advantages of axial flow pump

1, chemical axial flow pump: chemical axial-flow water pump drive motor is doing try totally enclosed deep-well three-phase asynchronous motor, can run into water for a long time, with traditional generator series of incomparable advantages.

2, due to the electrical and chemical of axial flow water pump body, don't have to be in the equipment on the spot to carry out the Labour organization, when motor, transmission system, the chemical industry on the centerline of the axial installation technological process, equipment on the spot, and quickly.

3, low noise, no heat in the wastewater treatment plant, improve the actual operating environment, consider underground sewage treatment plant can be built by the regulation, unremitting ground looks natural environment.

4, chemical key is to rely on blade axial-flow pump air resistance to fluid mechanics to the entrance, in radial, radial, has the advantages of big traffic.

chemical axial-flow pump repair and maintenance of

1, chemical axial-flow pump after stop using, want to do chemical axial flow pump and the pipe with water, soil and the outside world clean and tidy, prevent freezing water after freezing the pump shell and the water pipe burst.

2 chemical axial flow of axial flow pump bottom valve, elbow, such as aluminum die casting, should use steel brush brush rust net, then wipe anti-corrosive paint on first and then coated with paint, after being dry mania again into the computer room or storage room natural ventilation dry bath area of the store.

3, with synchronous belt transmission, the transmission belt removed after cleaning wipes with the warm boiling water in dry mania, without the sun point-blank area immediately, but also don't have to be stored in a oily be soiled, etching and smoke. No matter in what situation, don't have to make the belt with a car engine oil, diesel engine or motor gasoline chemical raw materials such as oil, need not coating resin and the viscosity of chemicals.

4, check the rolling bearing, such as the damage of sport coats, kuang, damage to the steel ball, or surface shading must be moved around. For without changing with motor gasoline or petrol will clean and tidy, rolling bearing with unsalted butter, put on again.

5, check the chemical industry is the impeller of axial flow pump has crack or small round hole, the impeller fixed nut is loose, if any damage should be repair or conversion. If impeller damage or too much is bad, the general should be changing a new impeller. Check the impeller wearing ring gap, such as beyond the standard, should be repaired or conversion.

6, serious chemical to bend or damage to the axial flow pump shaft, should repair or changing, or it will cause the damage of the motor rotor imbalance and related components.