How to fixed - screw vacuum pump installation

use screw vacuum pump or pump installation, must pay attention to the fixed pump must be correct, to ensure that its application and the installation process will not run freely. The water pump housing must be stable. Only to be firmly fixed, can ensure that all the normal application of the pump, and reduce common faults caused by vibration. In normal circumstances should be how to solve?

1。 Check basic quality: should base surface leveling around the block, pressure test block, block check good contacts after installation.

2。 Motor shaft machine installation: screw basic buried, put the screw vacuum pump, based on the adjustment pump iron wedge MATS, correctly after tighten the foundation screw.

3, base with concrete grouting and anchor bolts.

4。 After concrete setting, check whether the screw vacuum pump base and foundation screw is loose, tighten the foundation screw, to check the pump shaft roughness once again. On the basis of put a layer of smooth surface cleaning mortar concrete protective layer thickness, the ban on block.

5。 When transmission between pump and motor, the first installation of transmission, because it is a standard configuration before installing the pump and motor. Based on pump, adjust the pump shaft and motor shaft alignment, and then adjust the machine.

6。 After installation of pipeline and annotation, check the alignment again.

as a result, it can be seen that the anchor bolt must tighten, not loosen. Attention must put the screw vacuum pump in mind, don't let it vibrate. Repaired. This is to ensure the stability of its application in the whole process. In addition, according to reduce the vibration of the fixed, loose can reduce the risk of internal parts.