Just to create the best lamps.

J&T

Water ring vacuum pump unit _

by:J&T     2020-07-07

water ring vacuum pump unit can be understood as water ring vacuum pump closed loop system, water ring vacuum pump suction station, roots water ring vacuum unit, this kind of products in many users mind called water ring vacuum pump unit, each unit composition and under water ring vacuum pump function description is as follows:

water ring vacuum pump closed loop system:

water ring vacuum water pump closed loop system generally by the water ring vacuum pump, vapor separator, heat exchanger, a single by valve, water supply solenoid valve, ball valve, pipe, electric contact vacuum gauge, control cabinet, frame, etc. Main function is the working fluid in recycled water ring vacuum pump, a general lack of chemical industry and water resources. Enterprises can use this water ring vacuum pump unit, which can greatly reduce the sustainable use of water or chemical liquid, so as to reduce the cost of the enterprise.

water ring vacuum pump suction station:

water ring vacuum pump suction station generally by the water ring vacuum pumps, vacuum buffer tank, steam separator, heat exchanger, check valve, water supply solenoid valve, ball valve, pipe, control cabinet, vacuum gauge, frame and so on, are mainly function is stored in the negative pressure during the run for negative pressure demand certain negative pressure, and ensure the supply of negative pressure, and also effective to save water resources, and in the case of antiskid separator and the heat exchanger, can directly form water ring vacuum pump and the vacuum buffer tank, also can form water ring vacuum pump suction station. No matter what kind of water ring vacuum negative pressure stand, can be equipped with. Electric contact vacuum gauge and control cabinet by adjusting the upper and lower bounds of vacuum to control the start and stop of vacuum pump. The water ring vacuum pump unit in the healthcare industry and a v-shaped has common application in foundry industry. Water ring vacuum unit

:

roots water ring vacuum unit generally consists of water ring vacuum pump, check valve, ball valve, corrugated pipe, roots vacuum pump, water supply solenoid valve, control cabinet, electric contact vacuum gauge, pipes, frame, etc, for roots water ring vacuum unit, vacuum unit is closed cycle water ring pump system and water ring vacuum negative pressure station with large pumping speed, the advantage of high vacuum degree, roots water ring vacuum unit roots pump as the main pump, water ring pump is backing pump in series connection.

roots water ring vacuum unit use water ring pump as the backing pump. It is more advantageous than other vacuum pump. When using a single water ring pump, it overcomes the limit of the differential ( Compared with water ring water pump, the limit of unit pressure greatly improved) 。 A disadvantage of low pumping rate under pressure, while keeping the roots pump can work rapidly and has the advantages of large pump speed.

in particular, can adapt to remove large condensing steam, especially when the gas ballast mechanical vacuum pump oil seal, in order to eliminate the condensing steam capacity is not enough, or the use of solvent can make pump oil degradation, and impact performance, or the vacuum system does not allow oil pollution more obvious. If equipped with explosion-proof motor and electric appliance, and conform to the relevant safety rules, you can also remove inflammable and explosive gas. Therefore, roots pump - Water ring pump unit is widely used in chemical industry of vacuum distillation, vacuum evaporation and crystallization dehydration; The freeze drying in food industry; The pharmaceutical industry vacuum drying; Polyester chip in the textile industry; In the simulated altitude test of vacuum aspiration in the system. Roots water ring vacuum unit maximum pumping speed of main pump pumping speed ( Roots pump) Decision. Roots water ring vacuum unit limit vacuum:

( 1) Water ring vacuum unit, the second ( Roots pump + water ring pump) 267 pa, mercury vacuum gauge can measure McIntosh;

( 2) Water ring vacuum unit, level 3 ( Roots pump, roots pump and water ring pump) 25 pa, mercury vacuum gauge measured McIntosh;

( 3) Water ring vacuum unit, four ( Roots pump + roots pump, roots pump and water ring pump) 0. 5 pa, measurable digital vacuum gauge. Roots water ring pump is the power of water ring vacuum unit and the sum total of Roots pump motor. Roots water ring vacuum unit is widely used in textile, food, chemical, pharmaceutical and other industries of dry, dehydrated, vacuum degassing and distilling.


This is an internationally recognized standard which acts as a form of guarantee that everything J&T INDUSTRY CO.,LTD. does is managed to the highest quality standards.
Now you can enjoy winter cover pump with J&T INDUSTRY CO.,LTD.'s latest collection of pool cover drain pump water pump products. Do visit now, at J&T INDUSTRY.
water pump also offers several other winter cover pump that could potentially be useful for manufacturers.
Chat Online
Chat Online
Chat Online inputting...
Sign in with: