Mining wear-resisting pump start-up, operation and lubrication protection

Such as plate fixed or have abnormal sound, should check in time. Check the external first begin when check whether the coupling level, from the mirror of oil in the bearing hole to see if the location of the lubricating oil in the oil mirror (near the center line of Too much should be put off some, too little should add some) , check and plate movement, if the problem still exists, be about to dismantle the pump checking ( When the pump is going to hurt, please reference manual on the structure diagram and disassembling procedures) , clean house, and contact the factory consultation solution, at the same time, check the cooling water cooling system, whether outside or raises ( Deposit) Cooling oil. Open the outlet valve again

mining wear-resisting water pump running

if there are any abnormalities in the operation of the voice, or a motor the abnormal cases such as fever, also should stop check, inspection methods and steps as above ( Run before the inspection) 。 Cut off the power supply, and promptly close the inlet valve

mining wear-resisting water pump and the lubrication of the bearing maintenance

should be replaced regularly lubricating oil in the bearing seat ( 20 # engine oil) , general 6 months to run for the replacement cycle. Infuse lubricating oil level with the center line of the oil to the mirror as well ( See the figure) 。 High oil level is too low, no lubrication, shaft power consumption load increases.

J&T INDUSTRY CO.,LTD. thinks that a good rule of thumb to determine whether you're working on a project.
Grab great deals to buy at J&T INDUSTRY CO.,LTD.. Visit us today on J&T INDUSTRY.
comes in a vast array of styles and pool cover drain pump depending on which winter cover pumpis used.